CNC Code Shooter Mill and Lathe 2.05

10/03/08 - Generate, save, and print CNC Machine Code (G-code).





CNC Machine G-code generator for lathes, tool nose radius, corner or fillet radius, set clockwise or counterclockwise, set drill depth and feed rate, add G-codes and M-codes, set threads per inch, set up sheet, V thread or Acme, set rapid, set feed, add new tool, set spindle speed, forward or reverse, G76, choose a straight or tapered thread, x, z rapid to position, x start thread diameter, depth of cut, threads per inch, G92, set major or minor diameter, set min. and max cut, straight or tapered thread, Face, set x, z start and finish, set depth of cut, retract after cut amount, feed rate, 1 or 2 line G72, G70, Groove, groove width, closest edge to face, radius at top, radius at bottom, part and groove diameter, mic over balls, set angle off of face, ball diameter, ID or OD. Several changes such as combined mill and lathe together, support for G92, and taper per foot instead of angles, and other improvements.
Version 2.05 combines Mill and Lathe together.

Randall Ellison

Similar programs.

• CNC Code Shooter Mill and Lathe 1.3.1, 28.08.08

• CNC Code Shooter Mill 1.3, 24.03.08

• CNCEditMan, 18.05.07